Do it yourself
Frequently asked questions about cars and motorcycles
This guide shows how to reset the scheduled maintenance light on a BMW S1000RR. To perform this maintenance, you will need a diagnostic device with an OBD connector (OBDLink), the MotoScan software, and a cable with an OBD-10pin connector. With the instrument panel on, the first step is to connect the adapter cable to the socket on the motorcycle; then connect the OBDLink to the newly installed cable. Connect your mobile phone via Bluetooth to the OBDLink network. Before performing any operations, check for firmware updates for the OBDLink. From the MotoScan application, you can reset the service light; it is recommended to purchase the pro version of the application. Select the motorcycle model; select the tab related to the instrument cluster and wait for the procedure to complete; clicking on the selected tab again will show the service reset button. From this page, you can modify some parameters related to the warning light. After pressing the reset button, the warning light will turn off on the instrument panel. At this point, you can turn off the engine and disconnect the device. Check the success of the operation by turning the instrument panel back on.

Updated on 18 April 2026 by ScegliAuto

Video tutorial

Related tutorials

S1000 Rr In this tutorial, you will see how to change the engine oil in a BMW S1000RR, a very simple and quick operation. First, ensure that the engine is coo…
S1000 Rr To change the engine oil of a BMW S1000RR, start by ensuring that the engine is cold. Lift the motorcycle with a center or side stand to make it stab…
S1000 Rr To change the motor oil of a BMW S1000RR, start by warming up the engine for a few minutes to make the oil more fluid. Turn off the engine and put th…

How to Replace the Air Filter on a Honda CB500X?

Replacing the air filter on the Honda CB500X, as shown in this tutorial, is a very simple and quick operation. First, remove the seat, then loosen the nut securing the negative terminal of the battery, disconnect it, and repeat the process for the positive terminal. Next, detach the upper strap, remove the battery, and unscrew the 4 screws securing the airbox cover. Once opened, you can extract the old filter, remove any residue present in the housing, and fit the new part.

Watch the video!


by ScegliAuto

More videos