Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Remote Control Battery on a BMW R1200GS

Model: Bmw R1200gs
Part: Key

Video tutorial

This guide shows how to replace the battery on a BMW R1200GS remote control. In this case, the instrument panel displays a notification message for battery replacement and reduced functionality of the motorcycle.

First, open the key fob. Then, using your hands or a flathead screwdriver, pry open the battery compartment by lifting the plastic cover. Remove the old battery using the screwdriver and insert a new CR2032 button battery.

Close the remote and check the correct operation of the device before hitting the road.


Updated on 26 April 2026 by ScegliAuto


Related tutorials

Replacing the Battery of the BMW R1200GS
Replacing the Battery of the BMW R1200GS
R1200gs Follow these instructions to remove and replace the battery of the BMW R1200GS enduro motorcycle. First, place your bike on the stand and start by re…
How to Replace the Key Battery on the BMW R1200GS
How to Replace the Key Battery on the BMW R1200GS
R1200gs If your BMW R1200GS key has suddenly stopped working, it is likely time to replace the battery inside the cover. Below are the steps to follow. First…
How to Remove the Rear Wheel of a BMW R1200GS
How to Remove the Rear Wheel of a BMW R1200GS
R1200gs Before you can start, position your BMW R1200GS on the centre stand. Begin by loosening and removing the central nut that secures the rear wheel to t…

Vespa Immobiliser: How to Transfer the Chip from the Old Key

In the case shown in the video, the new keys are not recognised by the ECU: the Vespa starts but does not run (thus the immobiliser is active). The solution shown in the video involves locating the immobiliser chip in the old key (the one recognised by the ECU). Open the cover on the key (only red master keys or some blue ones), remove the chip (which is a small black cylinder or rectangle), insert it into the new key in place of the new one, and try to start. Now the key will work. If the master key is red, it will definitely work. If it is blue, it might work: you need to cut the silicone; this is possible but a delicate operation. If it is a black clone key, then it is a system that does not work.

Watch the video!


by ScegliAuto

More videos