|
Do it yourself
| |||
| ||||
Replacement of Front Window Regulator Motor
Model: BMW Serie 3
E46
- Years:
1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005, 2006
Video tutorial
Damage to the sliding pads of the window regulator system requires replacement of the entire system. Using a small plastic lever, remove the rectangular cap located in front of the internal handle and those positioned just below the armrest. Then, unscrew the screws located under the caps just removed. With the same plastic lever, detach the trim of the panel and unscrew the other two screws present. At this point, release the pressure clips along the edges of the panel and pull it upward to detach it from the weatherstrip; then disconnect the opening cable and the connectors for the speakers and remove the panel. Next, unscrew the screws securing the side airbag: to disconnect the airbag detonator connector, you must first lift the safety latch. Then peel off the sound-absorbing panel and remove it. Lower the window until the glass mounting pins align with the access holes in the door. Loosen the glass mounting pins and remove the glass. Disconnect the connector attached to the window regulator motor and unscrew all the mounting pins of the window lift system and remove it from the door. Then, detach the motor from the old window lift system and attach it to the new one, which can then be installed in the door and secured with the corresponding pins. Reconnect the connector to the motor and position the glass mounting pins as done previously; then insert the glass into the guides and tighten the mounting pins; reconnect the connectors and reassemble everything that was previously removed.
Updated on 3 February 2026 by ScegliAuto
Related tutorials
BMW Serie 3
(1998-2006 /
E46)
To replace the window regulator motor in your car, you first need to purchase a new one at a good price and of good quality.
The replacement procedur…
BMW Serie 3
(1998-2006 /
E46)
Today, we will see how to reset the window regulator motor of the BMW 3 Series model E46. To perform this procedure, turn on the ignition and press t…
BMW Serie 3
(1998-2006 /
E46)
Is the window regulator not working on your BMW 3 Series? Remove the door panel cover to access the interior. Disconnect the battery terminals for sa…
ScegliAuto offers an extensive international collection of automotive tutorials available in 12 languages. Each guide combines instructional videos with original explanations written by experienced human editors, along with information about the car models covered.
Other guides you may be interested in
|
Resetting the Tyre Pressure Monitoring System (TPMS) Light on the Toyota Yaris
These brief and simple steps will show you how to reset the tyre pressure monitoring system (TPMS) light on the Toyota Yaris. Before resetting the light, ensure that all four tyres are at the correct operating pressure. Get inside the vehicle on the driver's side and locate the TPMS reset button found at the bottom left of the dashboard (next to the steering wheel); press and hold it until the TPMS light on the instrument cluster resets, following the video until the end! by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.023
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy - About us VAT number: IT01247470535 |