Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Chevrolet
    3. :
  3. Camaro
    4. : 1993-2002 (MK 4)

Chevrolet Camaro Years 1993-2002 (MK 4)

Chevrolet Camaro (1993-2002 / MK 4)
Internal heating pipes replacement
The ducts that carry the water to the radiator for heating the passenger compartment are made partly of aluminum and partly of rubber: in the event of a leak, …read all…
Posted on 30 July 2023 by ScegliAuto
Chevrolet Camaro (1993-2002 / MK 4)
Engine oil and fillter replacement
To facilitate the operations of draining the oil from the sump, it is advisable to raise the car on a lift or on special platforms for cars. Then unscrew the …read all…
Posted on 29 July 2023 by ScegliAuto
Chevrolet Camaro (1993-2002 / MK 4)
Guide to replacing the engine air filter
A clogged air filter leads to reduced engine performance and excessive fuel consumption. Its function is to protect the engine by retaining impurities from the …read all…
Posted on 28 July 2023 by ScegliAuto
Chevrolet Camaro (1993-2002 / MK 4)
Water pump replacement instructions
Start by disassembling the intake duct; for easier access to some of the pins, it is also suggested to remove the plastic cover of the accelerator control and …read all…
Posted on 24 July 2023 by ScegliAuto
Fog lights (1) Air filter (2) Cabin air filter (2) Oil filter (2) Engine (1) Pump (1) Wheel (1) Fuse box (1) Windscreen wipers (1)

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos