Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the Battery and Dismantling the Key Remote.

Model: Chrysler Sebring St22, JR - Years 2000-2006
Part: Key

Use a screwdriver to lever open the slot where the two plastic halves of the key remote meet. Start at one point in the slot and continue around the perimeter until the two parts disengage. Once open, you will find the battery compartment in one half and the electronic board in the other half. There are two batteries, one mounted directly above the other. To remove them, use a screwdriver to lever them out. To extract the electronic board, press the function buttons on the key, and it will come out from its half. At this point, you can detach the rubber that indicates the function buttons and the transparent plastic that activates the switches on the board. This operation was performed on the key remote of a Chrysler Sebring.

Updated on 20 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacement of Front Suspension Wishbone
Replacement of Front Suspension Wishbone
Chrysler Sebring (2000-2006 / St22, JR) To replace the front suspension wishbone, lift the vehicle on suitable axle stands and remove the front wheel; then extract the safety pin from the n…
How to Change the Car Battery
How to Change the Car Battery
Chrysler Sebring (2000-2006 / St22, JR) First, lift the car with a jack to remove the front left wheel. After removing the wheel, unscrew the screws that secure the inner plastic of the whe…
Instructions for Replacing the Timing Belt
Instructions for Replacing the Timing Belt
Chrysler Sebring (2000-2006 / St22, JR) Only perform the timing belt replacement if you have a good understanding of general mechanics, as an error in positioning the belt or securing any p…

Other guides you may be interested in

Reset Tyre Pressure Light Toyota Yaris 2016

Due to advancements in onboard electronics, many vehicles are equipped with various sensors that monitor several operating parameters, including tyre pressure. Even if the pressure is correct, the warning light may sometimes illuminate on the dashboard. First, check with a gauge that the pressure in all 4 tyres matches the manufacturer's specifications. For the 2016 Toyota Yaris, the values are as follows: Front: 2.2 bar for T-type tyres, 2.3 for H-type, 2.4 for W-type. Rear: 2.2 bar for all tyre types. To reset the pressure light, turn on the ignition with the key, locate the reset button under the steering column. Press it for 3 seconds, and the light will flash 3 times before turning off. Remove the key from the ignition and start the vehicle.

Watch the video!


by ScegliAuto

More videos