Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Change the Car Battery

Model: Chrysler Sebring St22, JR - Years: 2000, 2001, 2002, 2003, 2004, 2005, 2006
Part: Battery

See other generations:
Video tutorial

First, lift the car with a jack to remove the front left wheel. After removing the wheel, unscrew the screws that secure the inner plastic of the wheel arch that protects the battery housing.

Once the battery is visible, unscrew the nuts connecting the cables to the terminals. Unscrew the two nuts that secure the metal bar holding the battery in place and remove the battery from its housing by levering it out with your hands.

To install the new battery, reverse the steps: place the battery in its housing, position the nuts on the two terminals, and tighten them. Reposition and screw in the metal bar that secures the battery, then replace the inner plastic of the wheel arch that protects the battery housing.

Refit the front left wheel and lower the jack. The car is a Chrysler Sebring.


Updated on 19 February 2026 by ScegliAuto


Related tutorials

Replacement of Front Suspension Wishbone
Replacement of Front Suspension Wishbone
Chrysler Sebring (2000-2006 / St22, JR) To replace the front suspension wishbone, lift the vehicle on suitable axle stands and remove the front wheel; then extract the safety pin from the n…
Replacing the Battery and Dismantling the Key Remote.
Replacing the Battery and Dismantling the Key Remote.
Chrysler Sebring (2000-2006 / St22, JR) Use a screwdriver to lever open the slot where the two plastic halves of the key remote meet. Start at one point in the slot and continue around the …
Removal and Replacement of Spark Plugs
Removal and Replacement of Spark Plugs
Chrysler Sebring (2000-2006 / St22, JR) This video shows how to remove and replace the spark plugs in your car. First, locate where the spark plug leads are positioned; in this case, three …

How to Reset the Tyre Pressure Warning Light on the Jeep Renegade?

To reset the tyre pressure warning light on the Jeep Renegade, inflate the tyres until they reach the recommended pressure: this value is indicated on the sticker attached to the driver’s door pillar. Once the tyres are properly inflated, navigate through the menu that appears on the instrument cluster until you find the tyre pressure option. At this point, press and hold the OK button on the right side of the steering wheel to make the warning light disappear.

Watch the video!


by ScegliAuto

More videos