Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacement of Front Suspension Wishbone

Model: Chrysler Sebring JR, St22 - Years 2000-2006
Part: Control arm

To replace the front suspension wishbone, lift the vehicle on suitable axle stands and remove the front wheel; then extract the safety pin from the nut that secures the wishbone ball joint to the hub support, unscrew the nut and use a fork puller to complete the disassembly; next, detach the anti-roll bar from the wishbone and then proceed to the bolts that secure the wishbone to the engine cradle; once the bolts are removed, you can take out the old wishbone and reverse the process to install the new one.

Updated on 17 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Instructions for Replacing the Wishbone Joint
Instructions for Replacing the Wishbone Joint
Chrysler Sebring (2000-2006 / JR, St22) At the ends of the wishbone arms of the suspension or the tie rods of the steering box, there are the so-called joints: these are ball joint assembli…
Replacement of Cabin Air Filter
Replacement of Cabin Air Filter
Chrysler Sebring (2000-2006 / JR, St22) The cabin air filter is located on the passenger side, behind the glove compartment door: open the door and detach the side cable to fully swing it d…
Front Wheel Hub Bearing Replacement
Front Wheel Hub Bearing Replacement
Chrysler Sebring (2000-2006 / JR, St22) To repair the front wheel hub bearing, you need to replace the entire hub complete with bearing; therefore, lift the vehicle and remove the front whe…

Other guides you may be interested in

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos