Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Instructions for Replacing the Wishbone Joint

Model: Chrysler Sebring St22, JR - Years: 2000, 2001, 2002, 2003, 2004, 2005, 2006
Part: Control arm

See other generations:
Video tutorial

At the ends of the wishbone arms of the suspension or the tie rods of the steering box, there are the so-called joints: these are ball joint assemblies that allow the suspension to provide maximum mobility; over time, the ball joint tends to wear out and become noisy, thus it needs to be replaced: to comfortably carry out the replacement, it is advisable to use a special clamp that allows the insertion of the ball joint pin into its seat; once the safety clip is removed and the fixing nut is unscrewed, the old joint can be extracted, possibly with a hammer blow, but the insertion of the new one should be done with the clamp to avoid jamming and damaging it.


Updated on 16 February 2026 by ScegliAuto


Related tutorials

Replacement of Front Suspension Wishbone
Replacement of Front Suspension Wishbone
Chrysler Sebring (2000-2006 / St22, JR) To replace the front suspension wishbone, lift the vehicle on suitable axle stands and remove the front wheel; then extract the safety pin from the n…
Instructions for Replacing the Timing Belt
Instructions for Replacing the Timing Belt
Chrysler Sebring (2000-2006 / St22, JR) Only perform the timing belt replacement if you have a good understanding of general mechanics, as an error in positioning the belt or securing any p…
Replacement of Cabin Air Filter
Replacement of Cabin Air Filter
Chrysler Sebring (2000-2006 / St22, JR) The cabin air filter is located on the passenger side, behind the glove compartment door: open the door and detach the side cable to fully swing it d…

How to reset the tyre pressure warning light on the Kia Niro EV?

To reset the tyre pressure warning light on the Kia Niro EV, inflate the tyres until they reach the correct pressure value. This value is indicated on the sticker attached to the driver's door pillar. Once the tyres are inflated, turn on the instrument cluster to check that the warning light has completely disappeared from the display. If it is still present, you may need to drive for a few miles to ensure it disappears completely from the screen.

Watch the video!


by ScegliAuto

More videos