Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacement of the steering tie rods on the Peugeot 206

Model: Peugeot 206 MK 1 - Years 1998-2012
Part: Tie rods

In this guide, you will find instructions on how to dismantle and replace the steering tie rods on the Peugeot 206 in simple steps. First, lift the vehicle and begin by removing the front wheel; then, unscrew the nut from the steering tie rod end, subsequently removing the tie rod by disconnecting it upstream, as shown in the video. At this point, install the new original steering tie rod with the new end; then, reassemble the front wheel, following the same procedure for replacing the other tie rod and steering end.

Posted on 13 September 2026 by ScegliAuto

Video tutorial

Related tutorials

Oil Filter Replacement on a Peugeot 206
Oil Filter Replacement on a Peugeot 206
Peugeot 206 (1998-2012 / MK 1) Replacing the oil filter on a Peugeot 206? Here’s how to remove it from the engine bay. Lift the bonnet and secure it, then use a strap wrench to uns…
Timing Belt Replacement on Peugeot 206
Timing Belt Replacement on Peugeot 206
Peugeot 206 (1998-2012 / MK 1) Remove the timing belt on the Peugeot 206 if it needs changing. Changing the timing belt is very important to avoid damaging the engine. Here’s how t…
Changing Oil on Peugeot 206 1.1
Changing Oil on Peugeot 206 1.1
Peugeot 206 (1998-2012 / MK 1) Learn how to replace the engine oil on a Peugeot 206. Lift the bonnet to remove the oil filter. Raise the vehicle on a column lift or jack, unscrew t…

Other guides you may be interested in

How to Repair the Key Spring of the Peugeot 207?

Over time, frequent use of the key's flip mechanism in the vehicle, dozens of times a day, inevitably leads to wear of the internal spring. As shown in this video, replacing the spring is quite simple and takes little time. After opening the casing halfway, first position the key, then the spring housing, and finally insert the spring into the previously mentioned housing. Close the casing by rotating it clockwise, ensuring all components fit perfectly, and test the key's flip mechanism.

Watch the video!


by ScegliAuto

More videos