Do it yourself
Frequently asked questions about cars and motorcycles
In order to disassemble the gearbox casing on the Derbi Senda 50, you first need to remove the clutch from its housing and then unscrew the screws that secure the gearbox casing. At this point, you can proceed by opening the casing so that all the gears inside can be identified: these can be removed from their housing by also removing the corresponding bearings. In this way, you can close the gearbox casing again, securing the covers with the appropriate screws and verifying that everything is functioning properly.

Posted on 14 September 2024 by ScegliAuto

Video tutorial

Related tutorials

Senda 50cc This operation must be performed with the engine cold. Before starting, position your Derbi Senda 50 on the side stand. Begin by disconnecting the ca…
Senda 50cc Before you begin, sit on the seat of your Derbi Senda. Start by inserting the key into the ignition switch and turning it fully clockwise. Next, pull…
Senda 50cc Before you can begin, position your Derbi Senda 50 on the side stand. Start by unscrewing and removing the bolts that secure the seat to the frame, l…

How to Replace the Battery in a Yamaha Vino 125 Scooter?

In this tutorial, you will see how to replace the battery in a Yamaha Vino 125 scooter, a very simple and quick operation. First, ensure that the key is not inserted for safety. Then, lift the rubber mat and, using a simple cross-head screwdriver, unscrew the two screws securing the plastic cover. Once opened, disconnect both terminals, starting with the negative, and remove the battery from its housing. To fit the replacement, simply follow the reverse procedure.

Watch the video!


by ScegliAuto

More videos