Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Chain on a Derbi Variant 50?

Model: Derbi Variant 50
Part:

Video tutorial

You can replace the chain on a Derbi Variant 50 by breaking the old chain at a point using the appropriate chain cutter. Once the old chain is opened, you can slide it off the corresponding sprockets.

This way, you can position the new replacement piece around the sprocket and the rear sprocket. Then, close the chain at the point where it is open by inserting the appropriate pin. Once it has been tensioned correctly, you can check that everything is functioning properly.


Posted on 9 March 2026 by ScegliAuto


Related tutorials

How do you replace the clutch springs of the Derbi Variant?
How do you replace the clutch springs of the Derbi Variant?
Variant 50 In order to replace the clutch springs of the Derbi Variant, you have to completely remove this component from its housing: the clutch is located in …
How do you replace the clutch of the Derbi Variant 50?
How do you replace the clutch of the Derbi Variant 50?
Variant 50 To replace the clutch of the Derbi Variant 50, you will need to loosen the screws that hold the transmission casing, located on the right side of the…
How do you replace the clutch on a Derbi Variant 50?
Variant 50 To replace the clutch of the Derbi Variant 50, you need to loosen the screws that secure the transmission cover located on the right side of the moto…
ScegliAuto offers an extensive international collection of automotive tutorials available in 12 languages. Each guide combines instructional videos with original explanations written by experienced human editors, along with information about the car models covered.

How to Reset the Engine Light on a Yamaha Ray RZ?

To reset the engine light on a Yamaha Ray RZ, connect a diagnostic tool to the vehicle's OBD port. The OBD port is located just above the battery housing, accessible by removing the panel in the centre of the footwell. Once this panel is removed, connect the scanner and select the car model and its corresponding version. After connecting the scanner and following the tutorial steps, you will notice that the light has been reset.

Watch the video!


by ScegliAuto

More videos