Do it yourself
Frequently asked questions about cars and motorcycles

Model: Derbi Senda 50cc
Part:

In this video, you will learn how to remove the chain and sprocket from a Derbi Senda 50cc, following the instructions below. First, detach the motorcycle chain by removing the chain guard and the sprocket. Then, unscrew the rear wheel bolt and tap from the opposite side to release the central pin, as illustrated in the video. Now, once the wheel is removed, unscrew the sprocket mounting bolts using a socket wrench to take it off and replace it. Reassemble everything by applying the reverse procedure!

Updated on 6 April 2026 by ScegliAuto

Video tutorial

Related tutorials

Senda 50cc In this video, you will see the main steps to replace the engine oil of a Derbi Senda 50cc. Before removing it, warm up the bike for a few minutes: t…
Senda 50cc This operation must be performed with the engine cold. Before starting, position your Derbi Senda 50 on the side stand. Begin by disconnecting the ca…
Senda 50cc Before you begin, sit on the seat of your Derbi Senda. Start by inserting the key into the ignition switch and turning it fully clockwise. Next, pull…

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos