Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Change the Engine Oil on a Derbi D50-B

Model: Derbi D50b
Part: Engine oil

Video tutorial

Let's discover the steps to change the engine oil as part of the regular maintenance service on a Derbi D50 enduro bike. First, warm up the engine for a few minutes to thin the oil; then place the bike on a stand and unscrew the oil drain bolt located under the engine using a socket spanner.

Allow the oil to drain for about ten minutes before replacing the plug; finally, fill the sump with new engine oil until it reaches the maximum level!


Updated on 13 April 2026 by ScegliAuto


Related tutorials

How to Start a Derbi D50B
How to Start a Derbi D50B
D50b Before you begin, position your Derbi D50B on its stand. Start by inserting the key into the ignition barrel and turn it fully clockwise. Next, open …
How to Replace the Clutch on a Derbi D50B?
How to Replace the Clutch on a Derbi D50B?
D50b To replace the clutch on a Derbi D50B, first remove the bolts securing the cover located on the right side of the bike, near the kickstarter. By unsc…
How to Remove the Cylinder from the Derbi D50B Engine Block?
How to Remove the Cylinder from the Derbi D50B Engine Block?
D50b To remove the cylinder from the Derbi D50B engine block, first remove the spark plug and unscrew the bolts of the detachable head. Disconnect the tem…
ScegliAuto offers an extensive international collection of automotive tutorials available in 12 languages. Each guide combines instructional videos with original explanations written by experienced human editors, along with information about the car models covered.

How to Reset the Engine Light on a Yamaha Ray RZ?

To reset the engine light on a Yamaha Ray RZ, connect a diagnostic tool to the vehicle's OBD port. The OBD port is located just above the battery housing, accessible by removing the panel in the centre of the footwell. Once this panel is removed, connect the scanner and select the car model and its corresponding version. After connecting the scanner and following the tutorial steps, you will notice that the light has been reset.

Watch the video!


by ScegliAuto

More videos