Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the Cylinder from the Derbi D50B Engine Block?

Model: Derbi D50b
Part: Checks and maintenance

Video tutorial

To remove the cylinder from the Derbi D50B engine block, first remove the spark plug and unscrew the bolts of the detachable head. Disconnect the temperature bulb cable to facilitate removal later.

Then, you can remove the additional 4 bolts of the detachable head and also remove the cylinder head. At this point, it will be possible to slide out the cylinder, and by removing the circlip, you can also remove the piston.

Once all parts have been removed, you can replace them with new parts and reassemble everything by performing the operations in reverse.


Updated on 18 April 2026 by ScegliAuto


Related tutorials

How to Start a Derbi D50B
How to Start a Derbi D50B
D50b Before you begin, position your Derbi D50B on its stand. Start by inserting the key into the ignition barrel and turn it fully clockwise. Next, open …
How to Replace the Clutch on a Derbi D50B?
How to Replace the Clutch on a Derbi D50B?
D50b To replace the clutch on a Derbi D50B, first remove the bolts securing the cover located on the right side of the bike, near the kickstarter. By unsc…
Disassembling the Engine Block on Derbi 50
Disassembling the Engine Block on Derbi 50
D50b Hello everyone! In this tutorial, you will learn how to separate the two cases of the engine block. Unscrew the bolts that hold them together. Rememb…
ScegliAuto offers an extensive international collection of automotive tutorials available in 12 languages. Each guide combines instructional videos with original explanations written by experienced human editors, along with information about the car models covered.

How to Reset the Engine Light on a Yamaha Ray RZ?

To reset the engine light on a Yamaha Ray RZ, connect a diagnostic tool to the vehicle's OBD port. The OBD port is located just above the battery housing, accessible by removing the panel in the centre of the footwell. Once this panel is removed, connect the scanner and select the car model and its corresponding version. After connecting the scanner and following the tutorial steps, you will notice that the light has been reset.

Watch the video!


by ScegliAuto

More videos