Do it yourself
Frequently asked questions about cars and motorcycles

How to Replace the Coolant in a Derbi Senda

Model: Derbi Senda 50cc
Part: Antifreeze coolant

Video tutorial

To replace the coolant in a Derbi Senda, open the reservoir by removing the cap. Once the cap for topping up is removed, also remove the smaller drain cap located on the side of the bike as shown in the video. Once all the old coolant has drained out, you can screw the drain cap back on and pour the new coolant in through the topping-up cap. Once you have finished topping up, you can screw the cap back on. To ensure all the old coolant is drained, you may need to tilt the bike.


Updated on 8 May 2026 by ScegliAuto


Related tutorials

Senda 50cc To replace the coolant in a Derbi Senda, loosen the bolts on the cover located at the end of the cooling duct. Once the cover is removed, collect the…
Senda 50cc This operation must be performed with the engine cold. Before starting, position your Derbi Senda 50 on the side stand. Begin by disconnecting the ca…
Senda 50cc To replace the brake fluid in the Derbi Senda 50, loosen the bolt that secures the end of the brake cable at the beginning of the swingarm: once this…

How to Assemble the Engine Block of the Husaberg FE 501

Here are the instructions to assemble the engine block of the Husaberg FE 501 enduro bike. First, assemble the engine transmission by installing the gear ratios and then the clutch assembly; after that, install the engine's thermal part by reassembling the crankshaft and then the cylinder head assembly (including piston, cylinder, and head), as shown in the video. At this point, install the stator and flywheel, as well as the electrical components of the engine, following the video tutorial to the end for reassembly!

Watch the video!


by ScegliAuto

More videos