Do it yourself
Frequently asked questions about cars and motorcycles
To replace the rear brake pads on the Derbi Senda 125, loosen the nut that secures the rear wheel to the end of the swingarm. Once this nut is loosened, you can detach the wheel and remove the chain from the corresponding sprocket. This will also allow you to loosen the bolt that secures the brake caliper to the rear disc: by doing this, the pads inside the caliper can be extracted and replaced with new spare parts. After replacement, reattach the caliper and mount all components.

Updated on 27 July 2026 by ScegliAuto

Video tutorial

Related tutorials

Senda 125 To replace the rear brake pads on a Derbi Senda 125, loosen the nut that secures the central axle of the rear wheel so that it can be completely remo…
Senda 125 To replace the rear brake pads of the Derbi Senda 125, loosen the nut that secures the central axle of the rear wheel so that it can be completely re…
Senda 125 To replace the exhaust on a Derbi Senda 125, completely unscrew the bolts securing it to its mounting: these are located at the top of the exhaust, n…

How to Replace the Engine Oil and Oil Filter on an Aprilia RSV 1000

This short video will show you how to carry out the routine maintenance service by replacing the engine oil and oil filter on the Aprilia RSV 1000 motorcycle. First, place your motorcycle on the centre stand and start by unscrewing the oil drain bolt located under the engine, allowing it to drain into a container for about ten minutes; then use the appropriate tool to unscrew and remove the oil filter, replacing the cartridge with a new one as shown in the video. Finally, unscrew the filler screw and top up by pouring in the suitable oil for your engine!

Watch the video!


by ScegliAuto

More videos