Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Dismantle the Engine of a Derbi Senda?

Model: Derbi Senda 50cc
Part: Engine

Video tutorial

To dismantle the engine of the Derbi Senda, completely remove the block from its housing by taking off the side panels and extracting it after disconnecting the connectors. Once the engine is removed, loosen the screws securing the two half casings to access the internal components.

You will need to remove the ring that secures the piston to its conrod and also loosen the bolts securing the clutch; this will allow you to replace the necessary parts to reinstall the engine.


Updated on 16 September 2026 by ScegliAuto


Related tutorials

How to Start a Derbi Senda
How to Start a Derbi Senda
Senda 50cc Before you begin, sit on the seat of your Derbi Senda. Start by inserting the key into the ignition switch and turning it fully clockwise. Next, pull…
How to Remove the Seat from a Derbi Senda 50
How to Remove the Seat from a Derbi Senda 50
Senda 50cc Before you can begin, position your Derbi Senda 50 on the side stand. Start by unscrewing and removing the bolts that secure the seat to the frame, l…
How to Replace the Spark Plug on a Derbi Senda 50
How to Replace the Spark Plug on a Derbi Senda 50
Senda 50cc This operation must be performed with the engine cold. Before starting, position your Derbi Senda 50 on the side stand. Begin by disconnecting the ca…

Vespa Immobiliser: How to Transfer the Chip from the Old Key

In the case shown in the video, the new keys are not recognised by the ECU: the Vespa starts but does not run (thus the immobiliser is active). The solution shown in the video involves locating the immobiliser chip in the old key (the one recognised by the ECU). Open the cover on the key (only red master keys or some blue ones), remove the chip (which is a small black cylinder or rectangle), insert it into the new key in place of the new one, and try to start. Now the key will work. If the master key is red, it will definitely work. If it is blue, it might work: you need to cut the silicone; this is possible but a delicate operation. If it is a black clone key, then it is a system that does not work.

Watch the video!


by ScegliAuto

More videos