Do it yourself
Frequently asked questions about cars and motorcycles

How to change the motor oil of a Royal Enfield Classic 350?

Model: Enfield Classic 350
Part: Engine oil

Video tutorial

To change the motor oil of a Royal Enfield Classic 350, start by placing the motorcycle on a flat and stable surface, preferably using a center stand. Make sure the engine is cold or slightly warm, as warm oil will flow better but won't be as dangerous as when it's boiling hot. Locate the oil drain plug, located under the engine, and place a suitable container to collect the old oil. Carefully unscrew the drain plug using an appropriate wrench, allowing the old oil to completely drain into the container.

Let the oil drain for a few minutes, to make sure there is no residual fluid left in the engine. Once the oil is completely drained, securely screw the drain plug back in, being careful not to overtighten to avoid damaging the thread.

After closing the plug, open the oil filler cap and pour the new oil into the engine, using a funnel to avoid spilling. Check that the amount of oil is correct by consulting the motorcycle manual.

Once the new oil is added, close the cap and start the engine for a couple of minutes, then turn it off and check the oil level again, topping up if necessary.


Posted on 16 September 2025 by ScegliAuto


Related tutorials

Classic 350 In this tutorial, see how to change the engine oil in a Royal Enfield Classic 350, a very simple and quick operation. First, ensure the engine is coo…
Classic 350 In this guide for Royal Enfield Classic 350 owners, we will discover where all the various fuses are located. First, ensure the motorcycle is complet…
Classic 350 In this guide, we will provide instructions for performing routine maintenance by changing the engine oil and oil filter on the Royal Enfield Classic…

How to Replace the Silencer on a Ducati Monster 696

This guide will show you how to remove and replace the silencer on a Ducati Monster 696 motorcycle, following the instructions below. First, place your motorcycle on a stand and start by unscrewing the fixing screw for the exhaust bracket. Then, disconnect the spring to remove the silencer from the exhaust manifold, as shown in the video. At this point, modify the manifold to install the new exhaust terminals; replace the entire exhaust if necessary by unscrewing the manifold nuts and applying the reverse procedure for reassembly!

Watch the video!


by ScegliAuto

More videos