Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Enfield Meteor 350
Part:

To replace the levers on the Royal Enfield Meteor 350, loosen the nuts located at the pins that secure the brake and clutch levers. Once these nuts are loosened, you can remove the corresponding pins and then disconnect the cables attached to the levers. After disconnecting these, the old levers can be removed from their housing, allowing you to insert the new ones. These should be secured in place, ensuring they function correctly.

Updated on 7 September 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Brake and Clutch Levers on the Royal Enfield Meteor 350
How to Replace the Brake and Clutch Levers on the Royal Enfield Meteor 350
Meteor 350 In today's video tutorial, see how to remove and replace the brake and clutch levers on the Royal Enfield Meteor 350 by following these simple steps.…
How to replace the battery of the Royal Enfield Meteor 350
Meteor 350 Today's instructions will show us how to disassemble and replace the battery of the Royal Enfield Meteor 350 motorcycle, in simple steps. First, we p…
How to disassemble the rear wheel of the Royal Enfield Meteor 350
How to disassemble the rear wheel of the Royal Enfield Meteor 350
Meteor 350 Today's procedure will show us how to replace the rear wheel of the Royal Enfield Meteor 350 motorcycle, in a few simple steps. First, we put the mot…

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos