Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Fiat
    3. :
  3. 500
    4. : How to remove the mirror from the bucket of a Fiat 500

Fiat 500 - Video tutorial

Model: Fiat 500 312 - Years 2007-2023
Part: Outside rearview mirror
Operation: How to remove the mirror from the bucket of a Fiat 500

How to remove the exterior mirror of a fiat 500? Let's see in this video how to proceed. With a plastic spatula we go to pry between the perimeter of the mirror frame and the mirror glass of the same. We pry until the slide comes off the mirror; very delicate operation because the slide or the mirror itself could break. Once the mirror has been removed from its housing: disconnect the glass power supply terminal (press the locking clips to disconnect the cover if it needs to be replaced). Finally we can replace the damaged part with the new one. We are careful to engage the plastic snap clips in the mirror supports.


Posted on 18 November 2023 by ScegliAuto

    Frequently Asked Questions

    • 500 2014-2022 - How much does it cost to replace the exterior rearview mirror on the Fiat 500X? Read Answer
    • 500 2007-2023 - How much does it cost to replace the side mirror on my Fiat 500? Read Answer
    • 500 2007-2023 - How much does it cost to replace the side rearview mirror on a Fiat 500? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos