Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Fit the Plastic Ring on the Gear Gaiter of a Fiat 500

Model: Fiat 500 312 - Years 2007-2021
Part: Shifter boot

In this video tutorial, learn how to fit the plastic ring on the gear gaiter of a Fiat 500 by following these simple and quick steps. First, remove the gear gaiter along with the old ring; then separate the two components as shown in the video. At this point, install the new ring, inserting it correctly into the holes of the gear gaiter to secure it; finally, reassemble the gaiter and, if necessary, the gear knob onto the lever, ensuring everything fits snugly without any play.

Updated on 26 April 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Gear Knob Gaiter on the Fiat 500L
How to Replace the Gear Knob Gaiter on the Fiat 500L
Fiat 500 (2012-2023 / 500 L) To replace the gear knob gaiter on the Fiat 500L (the video shows the entire lever removed, but this procedure can be done with the gear lever instal…
Replacing the Gear Gaiter on Fiat 500
Replacing the Gear Gaiter on Fiat 500
Fiat 500 (2007-2021 / 312) Removing the gaiter from the Fiat 500? Remove the knob to change the damaged gaiter. Use a screwdriver to remove the plastic cover on the knob, then …
Replacing the Gear Knob on a Fiat 500
Replacing the Gear Knob on a Fiat 500
Fiat 500 (2007-2024 / 312) In this video, you will learn how to remove the gear knob from a Fiat 500 city car. To do this, remove the plastic cap where the gear positions are m…

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos