Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Fiat
    3. :
  3. 500
    4. : Fiat 500 dipped beam replacement

Fiat 500 - Video tutorial

Model: Fiat 500 500 L - Years 2012-2023
Part: Headlight
Operation: Fiat 500 dipped beam replacement

Open the hood and put on the special support rod. For safety, you can disconnect the battery and take out the keys. Remove the cover on the underside of the headlight in question (no tools are needed for this). Bring the bulb out of its seat and disconnect it from the connector. Insert the new bulb you have purchased, making sure that it is firmly attached to the socket. Insert the bulb into the hole provided and replace the bottom cover that was initially removed. Reconnect the battery, in case you have disconnected it, and check the correct operation of the light.


Posted on 19 March 2024 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • 500 2012-2023 - What can be the reason why the daytime running lights on the Fiat 500 do not light up? Read Answer
    • 500 2007-2022 - Why don't the daytime running lights on the Fiat 500 work? Read Answer
    • 500 2007-2022 - What model are the front position light bulbs of the Fiat 500 series 312? Read Answer
    • 500 2007-2023 - How to remove the headlights on Fiat 500? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos