Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Rear Bushes of the Fiat Punto

Model: Fiat Punto MK 3, Punto EVO, 199, Grandepunto - Years 2005-2018

This guide outlines the main steps to disassemble and replace the rear bushes of the Fiat Punto, following the instructions below. First, lift the vehicle and remove the rear wheel; then disconnect the wishbone from the braking system to remove the old worn bush. Now, insert the new part into place, centring it perfectly; proceed to refit all components, applying the same procedure for replacing the other bush.

Updated on 9 May 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacing a Rear Silent Block on Fiat Punto
Replacing a Rear Silent Block on Fiat Punto
Fiat Punto (2005-2018 / MK 3, Punto EVO, 199, Grandepunto ) Learn how to replace the silent blocks without removing the rear axle, simply by lowering it. Disconnect the handbrake cables, then lift the rear of …
Removing the Rear Seats from a Fiat Punto
Removing the Rear Seats from a Fiat Punto
Fiat Punto (1999-2011 / MK 2, 188) In this brief and simple guide, we will see the instructions that will allow us to remove and replace the rear seats of the Fiat Punto. First, open t…
How to Remove the Rear Seat Backs from a Fiat Punto
Fiat Punto (2005-2018 / MK 3, Punto EVO, 199, Grandepunto ) Before you start, lower the two rear seat backs of your Fiat Punto. Begin by removing the carpet in the boot. Next, remove the lower bench of the rea…

    Frequently Asked Questions

    • Punto 2005-2018 - Where is the inertia switch on the Fiat Grande Punto? Read answer
    • Punto 2005-2018 - How many km does the Fiat Punto run in reserve? Read answer

How to Bleed the Clutch on a Renault Clio?

To bleed the clutch on a Renault Clio, open the bonnet to access the components located in the engine bay: here, you will need to undo the screws that secure the battery in its housing, the intake manifold, and the coolant reservoir. This will allow you to locate the pipe through which the brake fluid flows: by inserting the other end of the pipe into a container, you can press the clutch pedal to expel all the fluid until it fills the container.

Watch the video!


by ScegliAuto

More videos