Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to install octotelematics in the Fiat 500

Model: Fiat 500 312 - Years 2007-2021
Part: Antenna

In this video tutorial, you can see how to install the GPS "OCTO TELEMATICS" by following a few simple steps that will guide you towards proper vehicle management. First, lift the bonnet and secure it with the prop rod; take a cloth to clean the top of the car battery as the adhesive part of the "OCTO TELEMATICS" device needs to adhere well. Once the battery is clean, take the device, remove the film covering the adhesive part, and place the device firmly on the battery. Use a 10/11 spanner to loosen the nuts on the battery cables; connect the device's wires to the respective terminals (POSITIVE AND NEGATIVE) of the battery; tighten the battery nuts and you're done. At this point, a red light will flash on the device.

Updated on 12 May 2026 by ScegliAuto

Video tutorial

Related tutorials

Tow Bar Installation on Fiat 500 L Trekking
Tow Bar Installation on Fiat 500 L Trekking
Fiat 500 (2012-2023 / 500 L) In today's video, you will see how to install a tow bar on a Fiat 500 L, Trekking version. In this case, our vehicle is already prepared for the tow …
How to install the rearview mirror with camera on the Fiat 500 Abarth
How to install the rearview mirror with camera on the Fiat 500 Abarth
Fiat 500 (2007-2024 / 312) Today's main instructions will show us how to install the rearview mirror with rear camera on the Fiat 500 Abarth. First, we get on board the car and…
How to install the rear camera of the Fiat 500
How to install the rear camera of the Fiat 500
Fiat 500 (2007-2024 / 312) In this guide we will see the instructions that will allow us to install the rear camera of the Fiat 500. First of all, let's get the rear camera kit…

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos