Do it yourself
| ||||
|
Fiat Panda - Video tutorial
Model: Fiat Panda
MK 3, 319
- Years 2012-2023 To replace the Fiat Panda glow plugs, after carrying out a diagnosis and scanning, we notice that there is an error on the diesel injection (Before replacing it, we can check which of the 4 glow plugs is burned by connecting a bulb to a wire , connect it to the tip of the glow plug and the clamp to the positive pole of the battery and if we notice that the bulb turns on the wire is not interrupted, while when the bulb does not turn on the glow plug is burned out, so it must be replaced and it is it is preferable to change all 4), start with the replacement of the glow plugs by opening the engine hood, disconnect the 2 pipes leading to the air filter and the turbine cover, disconnect the upper cables of the glow plugs, with the help of a 9mm socket and various extensions unscrew the 4 glow plugs and remove them. Once the 4 glow plugs have been removed, take the new ones, spread grease on each glow plug, insert them into the appropriate holes, tighten them, connect the 2 previously removed pipes and the turbine cover. After this operation we pass inside the car, we delete the errors from the diagnostic program, we start the car for a few seconds and we notice that the glow plug light is off, we carry out a new scan in diagnosis thus noting that the error is solved. NB
Posted on 21 April 2024 by ScegliAuto
Other guides that may interest you
|
Frequently Asked QuestionsHow to reset the tire pressure warning light on Dacia Sandero?Let's see below how it is possible to reset the low tire pressure signal on the car: first of all it is necessary to check the correct tire pressure by comparing it with the pressures reported in the use and maintenance manual. After that, turn on the ignition and locate the command on the right side of the steering wheel at the top that allows you to access the on-board computer menu, then select the car symbol, after which select the "up arrow" command up to that the indication "tire pressure" appears on the display. At that point, press the "Ok" control on the steering wheel and keep it pressed to reset the signal. by ScegliAuto More videos
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.070
(c) ScegliAuto 2024 - info@scegliauto.com - Privacy Policy VAT number: IT01247470535 |