Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Glow Plugs in a Fiat Panda 1.3 MultiJet

Model: Fiat Panda 169, MK 2 - Years 2003-2012
Part: Glow plugs

In this video tutorial, you will see how to replace the glow plugs in a Fiat Panda 1.3 MultiJet by following some simple steps: the operation is straightforward but delicate, as the glow plugs are very fine in proportion to their length and are connected to the part of the engine that heats up the most, making them subject to sudden temperature changes. Their extraction may be complicated; therefore, it is recommended to apply penetrating oil where the glow plugs screw into their seat days before, repeating this operation daily until just before removal. First, disconnect the negative battery cable and remove the engine cover with the air filter housing. Use an air compressor to clean the seat to prevent dirt from falling into the combustion chamber once the glow plugs are removed. Remove the connectors from each glow plug by pulling them upwards as they are press-fitted; then, using an 8mm spanner, carefully unscrew the glow plugs as they may break. Install the new glow plugs without over-tightening.

Updated on 3 July 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Glow Plugs of the Fiat Panda
How to Replace the Glow Plugs of the Fiat Panda
Fiat Panda (2012-2026 / 319, MK 3) To replace the glow plugs of the Fiat Panda, after performing a diagnosis and scan, note that there is an error with the diesel injection (Before rep…
How to Replace the Spark Plugs in a Fiat Panda?
How to Replace the Spark Plugs in a Fiat Panda?
Fiat Panda (2003-2012 / 169, MK 2) To replace the spark plugs in a Fiat Panda, open the bonnet to detach the plastic cover on top of the engine block. At the front, you will find the c…
How to Replace the Timing Chain on the Fiat Panda 1.3 Multijet?
How to Replace the Timing Chain on the Fiat Panda 1.3 Multijet?
Fiat Panda (2003-2012 / 169, MK 2) To replace the timing chain on the Fiat Panda 1.3 Multijet, open the bonnet and remove the left side cover of the engine block, under which the timin…

Other guides you may be interested in

How to Open a Stuck Boot on the Peugeot 407?

On the Peugeot 407, the boot may become stuck, possibly due to a problem with the control button or the lock actuator. In such cases, you can perform an emergency opening by following the simple procedure shown in this tutorial. First, open the rear doors, then lower the seat back by operating the release lever. Next, go inside the boot, locate the lock, and manually operate it using a flathead screwdriver. The boot will then be free to open.

Watch the video!


by ScegliAuto

More videos