Do it yourself
Frequently asked questions about cars and motorcycles

How to Replace the Boot Gas Struts on a Fiat Grande Punto?

Model: Fiat Punto 199, MK 3, Grandepunto , Punto EVO - Years: 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015, 2016
Part: Checks and maintenance

See other generations:
Video tutorial

To replace the boot gas struts on a Fiat Grande Punto, disconnect the plastic retaining rings located at the top and bottom of the struts. Once these rings are removed, detach the strut connectors at both the top and bottom, accessible by opening the boot.

After removing the old struts, insert the new struts by securing them into the connectors and fitting the appropriate rings; finally, check that the boot closes properly.


Updated on 14 May 2026 by ScegliAuto


Related tutorials

Fiat Punto (2005-2018 / 199, MK 3, Grandepunto , Punto EVO) Opening the trunk of the Fiat Grande Punto from the outside is a simple and quick operation that can be done independently. To perform this action, w…
Fiat Punto (2005-2018 / 199, MK 3, Grandepunto , Punto EVO) This video demonstrates how to open the stuck boot of a Fiat Grande Punto. You will need to enter from inside, so fold down the rear seat and clear t…
Fiat Punto (2005-2018 / 199, MK 3, Grandepunto , Punto EVO) Let's see how to replace the front headlight bulbs of a Fiat Grande Punto. Open the bonnet by pulling the lever located at the bottom right of the da…

    Frequently Asked Questions

    • Punto 2005-2018 - What does the words "ESP, Hill holder not available" mean on the Fiat Punto Evo? Read answer
    • Punto 1999-2011 - How do you remove the headrest of the Fiat Punto 1.2? Read answer
    • Punto 2005-2018 - Where is the inertia switch on the Fiat Punto? Read answer
    • Punto 2005-2018 - How do i remove the center console of my Fiat Punto? Read answer

How to Reset the Tyre Pressure Warning Light on a Kia Rio?

The tyre pressure warning light displayed on the instrument cluster of the Kia Rio can be reset by inflating the tyres until they reach the recommended pressure value: this value is indicated on the sticker affixed to the driver's door pillar. Once all tyres have been inflated to the recommended pressure, turn on the ignition to check that the light has disappeared: if it is still present, it may be necessary to drive for a few miles, allowing the sensors to work and thus turning off the light.

Watch the video!


by ScegliAuto

More videos