Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Rear Headlamp Bulb on a Fiat 500L

Model: Fiat 500 500 L - Years 2012-2023
Part: Tail light bulb

This tutorial shows you how to remove the rear headlamp of a Fiat 500L to replace the bulb. First, open the boot of the vehicle and use a star screwdriver to unscrew the two screws next to the headlamp. After removing the screws, gently lever off the cover to detach it from the retaining clips at the edges. At this point, you have direct access to the headlamp, so unscrew the screws holding it in place, located on the top and rear. Now, extract the headlamp by pressing the tabs on the sides; retrieve the bulb holder and replace the bulb. Refit the headlamp and cover by screwing in the previously removed nuts.

Updated on 15 June 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacing the Front Headlight Bulb on the Fiat 500L
Replacing the Front Headlight Bulb on the Fiat 500L
Fiat 500 (2012-2023 / 500 L) In this video tutorial, you will learn how to remove and replace the front headlight bulb on the Fiat 500L, following the instructions below. First, …
How to Replace the Stop Bulb in a Fiat 500 L
How to Replace the Stop Bulb in a Fiat 500 L
Fiat 500 (2012-2023 / 500 L) In this video tutorial, you can observe how to replace the stop bulb in a rear light of a Fiat 500L. The first thing to do is to remove the rear opti…
How to Remove the Rear Bumper in a Fiat 500L
How to Remove the Rear Bumper in a Fiat 500L
Fiat 500 (2012-2023 / 500 L) Before you start, open the boot of your Fiat 500L. Begin by unscrewing and removing the screws that secure the rear bumper to the chassis, located ar…

    Frequently Asked Questions

    • 500 2007-2024 - How many reversing lights are there on the Fiat 500? Read answer

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos