Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Cabin Fan on a Ford Focus?

Model: Ford Focus MK 2, Focus 2 - Years 2004-2011
Part: Blower motor

Video tutorial
Detailed instructions - This tutorial shows how to replace the cabin fan on a Ford Focus, a very simple and quick operation. First, ensure that the instrument panel is off for safety. Then, go to the passenger side, open the glove compartment, detach it from the dashboard, locate the indicated bolt, and unscrew it with an 8mm socket. Next, close the glove compartment, remove the lower duct, and disconnect the power connector. At this point, unscrew the three fixing bolts of the fan, remove it from its housing, insert the replacement, and reassemble everything by following the reverse procedure.

Posted on 2 October 2026 by ScegliAuto


Related tutorials

Removing the Cabin Fan on Ford Focus
Removing the Cabin Fan on Ford Focus
Ford Focus (2011-2018 / MK 3) Learn how to remove the cabin fan on a Ford Focus. The cabin ventilation fan is located directly under the dashboard. Unscrew the securing screws on …
Replacing the Cabin Fan Resistor on a Ford Focus
Replacing the Cabin Fan Resistor on a Ford Focus
Ford Focus (2004-2011 / MK 2, Focus 2) Today's steps will show you how to remove and replace the cabin fan resistor on a Ford Focus. First, get inside the vehicle on the front passenger si…
Guide to disassembling the cabin fan of the Ford Focus
Guide to disassembling the cabin fan of the Ford Focus
Ford Focus (2011-2018 / MK 3) Today's instructions will show us how to disassemble and replace the cabin fan motor of the Ford Focus. First, we get on board the cabin and start di…

Other guides you may be interested in

How to reset the tyre pressure warning light on the Citroën DS4?

The tyre pressure warning light on the Citroën DS4 can be reset by inflating the tyres until they reach the corresponding pressure value, which is indicated on the sticker attached to the driver's door pillar. Once all tyres are at this value, turn on the ignition by inserting the key into the ignition switch; this should make the warning light disappear from the dashboard. If it does not reset, start the engine and drive to allow the sensors to read the new values.

Watch the video!


by ScegliAuto

More videos