Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the Rear Brake Pads of the Ford Kuga

Model: Ford Kuga C520, MK 2 - Years 2012-2019
Part: Brake pads

Below are the main instructions to remove and replace the rear brake pads of the Ford Kuga. First, lift the vehicle and begin by removing the front wheel; then, unscrew the bolts securing the brake caliper located at the back to detach it from the disc, as shown in the video. At this point, remove the old brake pads and replace them with new ones, pressing on the caliper piston and cleaning off any residual dirt; then reassemble everything by following the reverse procedure!

Updated on 24 May 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacement of the rear brake pads on a Ford Kuga
Replacement of the rear brake pads on a Ford Kuga
Ford Kuga (2012-2019 / C520, MK 2) Today we will see how to replace the rear brake pads on a Ford Kuga, second generation model produced from 2012 to 2019. We start the procedure by li…
How to Adjust the Handbrake on a Ford Kuga
How to Adjust the Handbrake on a Ford Kuga
Ford Kuga (2012-2019 / C520, MK 2) To adjust the handbrake on a Ford Kuga 2, park the vehicle on a flat surface and ensure it is secure. Access the area of the handbrake lever, located…
How to Replace the Rear Brake Disc and Pads on the Ford Kuga Mk2
How to Replace the Rear Brake Disc and Pads on the Ford Kuga Mk2
Ford Kuga (2012-2019 / C520, MK 2) This guide shows how to replace the rear brake discs and pads on the Ford Kuga Mk2. First, secure and lift the vehicle after removing the wheel bolts…

Other guides you may be interested in

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos