Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the Rear Bulbs

Model: Ford Focus MK 1 - Years 1998-2004
Part: Tail light bulb

Replacing the rear bulbs of the Ford Focus is quite simple and within everyone's reach, without the need to consult an auto electrician.
First, open the boot. The video shows how to operate with your fingers from the inside of the boot, and then how to unscrew the screws that hold the light unit to the bodywork. It then demonstrates how to extract the bulb holders from the light unit and the bulbs from the holders.
At the end of the video, you can see how to reassemble everything, obviously after replacing the blown or damaged bulbs.

The car model presented here is a three-door Ford Focus.

Updated on 2 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacing the rear light bulbs of the Ford Focus
Replacing the rear light bulbs of the Ford Focus
Ford Focus (2011-2018 / MK 3) Today's guide will show you the steps to remove and replace the rear light bulbs of the Ford Focus. First, open the tailgate of the boot and start re…
Replacing Car Brake Light Bulb
Replacing Car Brake Light Bulb
Ford Focus (1998-2004 / MK 1) Unlike household bulbs, car bulbs use a bayonet fitting. Replacing the bulbs does not require any special skills. Disconnect the wires supplying elec…
Replacing Rear Bulbs on Ford Focus
Ford Focus (2011-2018 / MK 3) Open the boot lid and manually remove the cover located in the internal frame of the boot (specifically on the side of the affected light), in this c…

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos