Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Ford
    3. :
  3. Focus
    4. : How to remove the headlight of the Ford Focus III

Ford Focus - Video tutorial

Model: Ford Focus MK 3 - Years 2011-2018
Part: Headlight
Operation: How to remove the headlight of the Ford Focus III

The disassembly of the headlight is extremely simple to carry out since there are no undercut elements (such as the bumper) with respect to the headlight itself and therefore you do not have to disassemble anything but the headlight alone; therefore open the front hood and secure it using the special support rod; then intercept the fixing screws of the headlight, one located in correspondence with the internal edge practically close to the mask and the other on the external edge near the mudguard; therefore unscrew the two screws and lift the headlight from its seat just enough to then disconnect the power socket and complete the disassembly.


Posted on 31 August 2023 by ScegliAuto

    Frequently Asked Questions

    • Focus 2011-2018 - What causes the Ford Focus low beam headlight problem? Read Answer
    • Focus 2004-2011 - How much does it cost to replace the Ford Focus Mk2 low beam bulb? Read Answer
    • Focus 2018-2025 - How to reset errors and fault codes of a Ford Focus 2018? Read Answer
    • Focus 1998-2004 - How to remove the alternator belt of a Ford Focus? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos