Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Ford
    3. :
  3. Focus
    4. : How to remove the rear door handle of the Ford Focus.

Ford Focus - Video tutorial

Model: Ford Focus MK 2, Focus 2 - Years 2004-2011
Part: Handle
Operation: How to remove the rear door handle of the Ford Focus.

First you need to remove the internal plastic panel that covers the rear door. To do this we must unscrew the six screws that secure it to the door along the entire perimeter. Then we have to unscrew the screw that is near the opening lever and the two screws that are in the handle under the plastic cover. Once this is done we can remove the panel. We begin to remove the plastic mask that is around the opening lever and disconnect the power supply for the electric windows. After we remove the triangular mask on the glass and finally we proceed to remove the panel. At this point we move the protection to the handle. We identify the position of the screw that blocks the handle and unscrew it. Now, using a screwdriver, we remove the handle from its position on the outside of the door. We proceed to assemble the new handle by repeating the same operations seen but performing them in the opposite procedure. We proceed in the same way for the reassembly of the door panel.


Posted on 17 September 2023 by ScegliAuto

Other guides that may interest you

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos