Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Bearing on the Ford Focus

Model: Ford Focus MK 2, Focus 2 - Years 2004-2011
Part: Bearing

To perform this operation, you will need to remove the wheel in question. Lift your vehicle and place it on suitable axle stands. Proceed to remove the parts that make up the brake system. You can follow the instructions provided in the video or refer to a specific guide on our website, scegliauto.com. Next, remove the disc and the ABS sensor. Extract the driveshaft from its housing using a rubber mallet. You will need a press to effectively remove the bearing.

Updated on 26 February 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Front Wheel Bearing on a Ford Focus
How to Replace the Front Wheel Bearing on a Ford Focus
Ford Focus (2011-2018 / MK 3) To replace the front wheel bearing on a Ford Focus, lift the car with a jack so that the wheel corresponding to the bearing to be replaced is not in …
Replacing the Rear Wheel Bearing on a Ford Focus MK2
Replacing the Rear Wheel Bearing on a Ford Focus MK2
Ford Focus (2004-2011 / MK 2, Focus 2) Replacing the rear wheel hub bearing on a Ford Focus MK2 is a DIY maintenance task since you can purchase the complete hub and do not need a press: y…
Replacement of Front Wheel Hub Bearing
Ford Focus (2004-2011 / MK 2, Focus 2) Replacing the front wheel hub bearing is quite straightforward, but it is advisable to have a press to extract the old one and insert the new one; th…

Other guides you may be interested in

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos