Do it yourself
Frequently asked questions about cars and motorcycles
In this video tutorial, you will see instructions on how to disassemble and replace the electric starter motor on a Gasgas EC 300 motorcycle. First, unscrew the mounting bolts of the starter motor, which are located on the left side of the bike; use a socket spanner. At this point, once removed, disconnect its power electrical connector to remove it completely. Then, replace it with the correct new one and the original spare part: apply the reverse procedure for reassembling the starter motor!

Updated on 27 April 2026 by ScegliAuto

Video tutorial

Related tutorials

Ec 300 In today's tutorial video, you will see how to install the starter motor on a Gasgas EC 250 and 300, following the instructions below. First, grease …
Ec 300 To replace the starter motor on the GasGas EC 300, detach the left side fairing of the bike, located near the bottom of the fuel tank. Once the panel…
Ec 300 To replace the starter motor on a GasGas EC 300, loosen the screws securing the corresponding cover panel located on the right side of the bike. Once…

How to Service the Piaggio Vespa GTS 300

This brief guide will illustrate the main steps to perform the routine maintenance service on the Piaggio Vespa GTS 300, replacing the engine oil and oil filter. First, place the scooter on the centre stand and start by unscrewing the oil drain bolt found under the engine, allowing it to drain into a container for about ten minutes; then unscrew the oil filter cartridge using the appropriate tool, and hand-tighten the new one. Finally, unscrew the filler cap and top up, filling to the maximum level mark!

Watch the video!


by ScegliAuto

More videos