Do it yourself
Frequently asked questions about cars and motorcycles
The steps illustrated in this guide will show us how to disassemble and replace the rear turn signal bulbs of the Harley Davidson Sportster motorcycle. First, we put the motorcycle on the stand and start unscrewing the nuts found behind the rear fender, gently removing the turn signals; then we disconnect the electrical wiring, as shown in the video. After that, we replace and install the new rear turn signal bulbs, of the correct type; we securely attach them to the fender and finally check their operation, following the video tutorial until the end!

Posted on 13 November 2024 by ScegliAuto

Video tutorial

Related tutorials

Sportster Below are the steps to remove and replace the mirrors on the Harley Davidson Sportster. First, place the motorcycle on a stand and start unscrewing a…
Sportster In this video description, you will see how to remove and replace the original grips on a Harley Davidson Sportster in simple steps. First, unscrew t…
Sportster In today's guide, you will discover the main steps to remove and replace the battery on a Harley Davidson Sportster motorcycle. First, remove the sea…

How to Service the Beta RR 350

This video will illustrate the steps to perform the routine maintenance service, replacing the engine oil and oil filter on the Beta RR 350 enduro bike. First, place the bike on a stand and start by loosening the oil drain bolt located under the engine, allowing it to drain into a container for about ten minutes; then clean the small oil filter (replacing it with a new one if too dirty). Finally, top up with new oil, of the correct type for your engine, filling to the maximum level!

Watch the video!


by ScegliAuto

More videos