Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
This guide describes how to replace the engine oil and oil filter on a Harley Davidson Sportster 1200. Obtain 3 litres of Harley Davidson Genuine Oil SAE 20W50 and an HIFLO HF170B oil filter. Position the motorcycle on the central lift. Start the engine, allow it to reach temperature, and then switch off. Place a container for the used oil underneath the engine. Use a screwdriver to loosen the clamp holding the plastic oil drain plug. The plug is located at the rear bottom of the engine, either fitted into a rubber tube or secured with a clamp to the rear frame. Allow the oil to drain and clean the plug thoroughly. Use a socket wrench to remove the oil filter located on the lower left side of the engine, front part. Lubricate the gasket of the new oil filter and screw it in by hand. Refit the oil drain plug. Lower the motorcycle from the lift and place it on the side stand. Open the oil filler cap located on the right side of the oil tank. Pour in 2 litres of oil and start the engine for one minute, ensuring the oil warning light goes out, then switch off. Check the oil level on the dipstick and add oil up to the maximum level.

Updated on 9 March 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Change the Engine Oil of a Harley Davidson Sportster 1200?
How to Change the Engine Oil of a Harley Davidson Sportster 1200?
Sportster 1200 To change the engine oil of the Harley Davidson Sportster 1200, you will need to loosen the drain plug located at the bottom of the oil sump: once th…
How to Replace the Exhaust on a Harley Davidson Sportster 1200?
How to Replace the Exhaust on a Harley Davidson Sportster 1200?
Sportster 1200 To replace the exhaust on a Harley Davidson Sportster 1200, you will need to loosen the screws that secure the exhaust tip to its housing, located on…
Replacing the Battery on a Harley Davidson Sportster 1200
Replacing the Battery on a Harley Davidson Sportster 1200
Sportster 1200 In today's video, learn how to remove and replace the battery on a Harley Davidson Sportster 1200 in simple steps. First, remove the seat by unscrewi…

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos