Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Brake Pads on a Harley Davidson Sportster 883

Model: Harley Davidson Sportster Iron 883
Part: Brake pads

Video tutorial

In today's tutorial video, you will learn how to disassemble and replace the front brake pads on a Harley Davidson Sportster 883 Iron in simple steps. First, unscrew the bolts securing the brake caliper; then unscrew those of the caliper bracket, as shown in the video.

At this point, detach the caliper and remove the two old pads; clean the caliper area of any carbon residue and install the new pads of the correct type. Finally, reassemble them and apply the same replacement procedure to the other caliper!


Updated on 8 April 2026 by ScegliAuto


Related tutorials

How to Replace the Rear Brake Pads on a Harley Davidson Sportster Iron 883?
How to Replace the Rear Brake Pads on a Harley Davidson Sportster Iron 883?
Sportster Iron 883 To replace the rear brake pads on the Harley Davidson Sportster Iron 883, loosen the screws securing the rear brake caliper, located immediately next…
Replacing the front brake pads on the Harley Davidson Sportster Iron 883
Replacing the front brake pads on the Harley Davidson Sportster Iron 883
Sportster Iron 883 This guide will illustrate the steps to remove and replace the front brake pads on the Harley Davidson Sportster Iron 883. First, place the motorcycl…
How do you replace the spark plugs on the Harley Davidson Sportster Iron 883?
How do you replace the spark plugs on the Harley Davidson Sportster Iron 883?
Sportster Iron 883 To replace the spark plugs of the Harley Davidson Sportster Iron 883, you will need to disconnect the coils that are connected to the top of the engi…

How to Change the Gear Oil on a Vespa 125 LX?

To change the gear oil on a Vespa 125 LX, unscrew the drain plug of the reservoir that contains the oil: this is located at the lower rear of the transmission casing, on the left side of the bike near the rear wheel. Once the drain plug is removed, collect the oil in a container until it is empty. At this point, top up through the breather located at the rear of the bike by adding the necessary amount of oil and then close the plug.

Watch the video!


by ScegliAuto

More videos