Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to replace the rear brake shoes of the Honda Dio

Model: Honda Dio
Part: Brake drums and shoes

Video tutorial

This guide briefly outlines the instructions to remove and replace the rear brake shoes of the Honda Dio scooter, following these simple steps. First, place your scooter on the centre stand and begin disconnecting the rear brake cable using a socket spanner; then, unscrew the wheel bolts to remove the wheel, gaining access to the drum, as shown in the video.

At this point, remove the springs from the shoes to take them out, replacing them with new ones; reassemble the braking system and install the rear wheel!


Updated on 30 June 2026 by ScegliAuto


Related tutorials

How to Change the Engine Oil on a Honda Dio
How to Change the Engine Oil on a Honda Dio
Dio To change the engine oil on a Honda Dio, loosen the drain plug located at the bottom of the bike, near the beginning of the exhaust. This will allow …
How to Replace the Front Headlight Bulb of the Honda Dio
How to Replace the Front Headlight Bulb of the Honda Dio
Dio Let’s see together how to remove and replace the front headlight bulb of the Honda Dio scooter in simple and quick steps. First, place the scooter on…
How to Replace the Front Shock Absorber on the Honda Dio
How to Replace the Front Shock Absorber on the Honda Dio
Dio You can replace the front shock absorber on the Honda Dio by loosening the screws that secure it to its housing: start by loosening the bolt located …

How to Replace the USB Socket on the Benelli TRK 502?

To replace the USB socket on the Benelli TRK 502, loosen the screws securing the left side panel of the motorcycle, located just below the handlebars: once this panel is freed, you can remove it and locate the USB socket connector. By disconnecting this connector, you can pull the socket out of its housing: then connect the new socket to the connector, inserting it into its housing. After installation, check that the socket works by reinstalling the panel.

Watch the video!


by ScegliAuto

More videos