Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Husaberg Fe 570
Part: Engine

It will be possible to disassemble the engine of the Husaberg FE 570 by loosening the screws that secure the block to its housing in the central part of the frame: once the fastening screws have been loosened, it will be possible to proceed by loosening the screws that secure the manifolds and disconnecting the connectors. Then it will be possible to proceed by loosening the screws that secure the cylinder, removing it and accessing the piston inside: it will now be possible to remove it from the connecting rod in order to access the crankshaft and replace the necessary parts with new ones.

Posted on 6 August 2025 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Water Pump Gasket on a Husaberg FE 570
How to Replace the Water Pump Gasket on a Husaberg FE 570
Fe 570 This guide outlines the steps to disassemble and replace the water pump gasket on the Husaberg FE 570 enduro bike. First, disconnect the coolant hose…
How do you replace the exhaust pipe of the Husaberg FE 570?
How do you replace the exhaust pipe of the Husaberg FE 570?
Fe 570 In order to replace the exhaust on the Husaberg FE 570, you need to loosen the screws that secure the right side panel of the fender: this way you wi…
How to Replace the Fuel Pump on the Husaberg FE 570?
How to Replace the Fuel Pump on the Husaberg FE 570?
Fe 570 To replace the fuel pump on the Husaberg FE 570, loosen the plastics located on the sides of the fuel tank, which is installed at the front of the bi…

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos