Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the Engine from the Husqvarna FE 501?

Model: Husqvarna Fe 501
Part: Engine

Video tutorial

To remove the engine from the Husqvarna FE 501, loosen the screws that secure it to the supports. This will allow you to disconnect the cables related to the sensors, as well as the intake and exhaust pipes.

Once these are all removed, proceed to loosen the screws that secure the cylinder and the piston underneath. All these components can then be removed to access the internal part of the engine block.

Finally, once the necessary parts are replaced, close the block again, ensuring everything functions correctly.


Updated on 23 October 2026 by ScegliAuto


Related tutorials

How to Remove the Engine from the Husqvarna FE 501
How to Remove the Engine from the Husqvarna FE 501
Fe 501 To remove the engine from the Husqvarna FE 501, loosen the bolts securing it within its housing. Once these mounting bolts are loosened, disconnect a…
How to Replace the Engine Oil of the Husqvarna FE 501
How to Replace the Engine Oil of the Husqvarna FE 501
Fe 501 Discover the instructions for performing the routine maintenance service by replacing the engine oil and oil filter of the Husqvarna FE 501 motorcycl…
How to Change the Engine Oil in the Husqvarna FE 501?
How to Change the Engine Oil in the Husqvarna FE 501?
Fe 501 In this tutorial, you will see how to change the engine oil in the Husqvarna FE 501, a very simple and quick operation. First, ensure the engine is c…

How to Change the Engine Oil on a BMW R1200T?

To change the engine oil on a BMW R1200T, follow these steps. Ensure the bike is on a level surface and the engine is warm but not too hot. Remove the oil filler cap and the oil drain plug, usually located on the underside of the engine. Position a collection container under the drain plug and unscrew it to fully drain the used oil. Once drained, remove and replace the oil filter, ensuring to clean the mounting surface thoroughly. Install the new filter and screw the oil drain plug back in. Fill the engine with new oil through the filler cap until reaching the recommended amount, checking the level with the dipstick if necessary. Secure both caps tightly. Start the engine for a few minutes to circulate the new oil, then turn it off, and the replacement is complete.

Watch the video!


by ScegliAuto

More videos