Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to replace the sprocket of the Husqvarna TE 449

Model: Husqvarna Te 449

Video tutorial

In this guide we will see the instructions that will allow us to disassemble the sprocket (of the chain group, crown and sprocket) of the Husqvarna TE 449 enduro motorcycle, in simple steps. First, we put the motorcycle on the stand and start disconnecting the chain from the sprocket, removing the link; then we unscrew the two screws of the sprocket, removing the metal clip, as shown in the video.

At this point we clean or replace the sprocket, correctly fixing the new one; then we reassemble the transmission chain, following the video tutorial to the end!


Posted on 8 September 2025 by ScegliAuto


Related tutorials

How to Replace the Sprocket on a Husqvarna TE 449
How to Replace the Sprocket on a Husqvarna TE 449
Te 449 To replace the sprocket on the Husqvarna TE 449, first unscrew the pin that holds the rear wheel, removing it from the swingarm. Next, loosen the 14 …
How to Dismantle the Engine of the Husqvarna TE 450?
How to Dismantle the Engine of the Husqvarna TE 450?
Te 449 To dismantle the engine of the Husqvarna TE 450, extract it from its housing by loosening the screws that secure it to the supports and disconnecting…
How to Replace the Fuel Pump on a Husqvarna TE 450
How to Replace the Fuel Pump on a Husqvarna TE 450
Te 449 To replace the fuel pump on a Husqvarna TE 450, you need to loosen the screws securing the seat and the fuel tank. The pump will be located at the bo…

How to Replace the Air Filter on a Honda SH 300i Scooter?

In this tutorial, you will see how to replace the air filter on a Honda SH 300i scooter, a very simple and quick operation. Before proceeding, ensure the engine is completely cold for safety. Start by unscrewing both the 6 screws around the perimeter of the airbox and the 3 bolts of the circular cover, then remove the cover and unscrew the additional screw that has just been freed. Next, separate the box, remove the old filter, and clean the housing of any dirt residue. Finally, follow the reverse procedure to install the replacement.

Watch the video!


by ScegliAuto

More videos