Do it yourself
Frequently asked questions about cars and motorcycles

Model: Husqvarna Te 300i
Part:

Let’s discover in this video how to remove the fuel tank on the Husqvarna TE 300i enduro bike, as well as on KTM and Gasgas enduro models. First, remove the side plastic panels; then remove the seat of your bike and disconnect the fuel hoses from the tank located underneath, as shown in the video. At this point, use a Torx screwdriver to unscrew all the screws located above the tank, then disconnect the electrical connector of the float; all that’s left is to finally remove the fuel tank!

Updated on 28 April 2026 by ScegliAuto

Video tutorial

Related tutorials

Te 300i Today we will see the main instructions that will allow us to disassemble and replace the fuel pump and its filter of the Husqvarna TE 300i enduro mo…
Te 300i In order to replace the fuel tank of the Husqvarna TE 300i, you need to loosen the screws that secure the panels on the front side of the bike: these…
Te 300i Today's guide will illustrate the main steps to dismantle and replace the rear suspension of the Husqvarna TE 300i enduro bike. First, lift the bike …

How to Service the Beta RR 350

This video will illustrate the steps to perform the routine maintenance service, replacing the engine oil and oil filter on the Beta RR 350 enduro bike. First, place the bike on a stand and start by loosening the oil drain bolt located under the engine, allowing it to drain into a container for about ten minutes; then clean the small oil filter (replacing it with a new one if too dirty). Finally, top up with new oil, of the correct type for your engine, filling to the maximum level!

Watch the video!


by ScegliAuto

More videos