Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Plastic Fairings on the Husqvarna TX 300i

Model: Husqvarna Tx 300
Part:

Video tutorial

The following steps will guide you through the process of removing and replacing the plastic fairings on the Husqvarna TX 300i enduro bike. First, place the bike on a stand and begin unscrewing the screws from the side fairings to remove them; you may need to pry them off from the clips, as shown in the video.

Next, remove the seat and, if necessary, take off the rear tail fairing; install the new fairings and secure them properly, ensuring they are compatible and do not vibrate while riding.


Updated on 27 September 2026 by ScegliAuto


Related tutorials

How to Replace the Sprocket, Pinion, and Chain on a Husqvarna TX 300
How to Replace the Sprocket, Pinion, and Chain on a Husqvarna TX 300
Tx 300 In this video tutorial, see how to disassemble and replace the transmission kit (sprocket, pinion, and chain) on the Husqvarna TX 300 enduro bike. Fi…
How to Change the Engine Oil on a Husqvarna TX 300?
How to Change the Engine Oil on a Husqvarna TX 300?
Tx 300 You can change the engine oil on a Husqvarna TX 300 by loosening the drain plug located at the bottom centre of the instrument panel, allowing the us…
How do you replace the stator of the Husqvarna TX 300?
How do you replace the stator of the Husqvarna TX 300?
Tx 300 It will be possible to replace the stator of the Husqvarna TX 300 by loosening the screws that secure the specific cover housing located on the left …

How to Set the Time on a Suzuki Burgman 650 Scooter?

In this tutorial, you will learn how to set the time on a Suzuki Burgman 650 scooter, a very simple and quick operation to perform after disconnecting the battery or when switching to daylight saving time. First, insert the key, then turn on the instrument panel and press the two buttons located below the display until the clock starts to flash. At this point, adjust the hour using the "Select" button, set the minutes with the "Adjust" button, and save the setting by pressing both buttons again.

Watch the video!


by ScegliAuto

More videos