Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
To change the motor oil of a Husqvarna FE 501, start by placing the motorcycle on a stable support and make sure the engine is warm, so the oil will flow better. Under the engine, locate the oil drain plug. Use a suitable wrench to unscrew the plug and let the used oil drain completely into a suitable container. Once the oil is completely drained, screw the drain plug back in, making sure it is tight. Next, open the oil fill cap on the engine, usually located above the engine block. Pour in the new oil, following the manufacturer's recommended specifications, using a funnel to prevent spills. After adding the correct amount, reattach the fill cap and make sure it is securely fastened. Start the engine and let it run for a few minutes, then check for any leaks and verify the oil level. Finally, check the drain plug for any leaks and make sure everything is in order.

Posted on 30 July 2024 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Engine Oil of the Husqvarna FE 501
How to Replace the Engine Oil of the Husqvarna FE 501
Fe 501 Discover the instructions for performing the routine maintenance service by replacing the engine oil and oil filter of the Husqvarna FE 501 motorcycl…
How to Change the Engine Oil on the Husqvarna FE 501
How to Change the Engine Oil on the Husqvarna FE 501
Fe 501 Today, follow these steps to perform the routine maintenance service by changing the engine oil on the Husqvarna FE 501 enduro bike. First, place the…
How to Change the Engine Oil in the Husqvarna FE 501?
How to Change the Engine Oil in the Husqvarna FE 501?
Fe 501 In this tutorial, you will see how to change the engine oil in the Husqvarna FE 501, a very simple and quick operation. First, ensure the engine is c…

How to Replace the Battery in a Yamaha FZ6?

Replacing the battery in the Yamaha FZ6, as shown in this tutorial, is a very simple and quick operation. First, ensure that the key is not inserted, then remove the rider's seat and, using a 10mm socket spanner, loosen the bolt on the tank hinge. Next, unscrew both the front bolts and the fairing mounting bolts, lift the entire tank, and disconnect both terminals starting with the negative. At this point, you can remove the upper plastic plate, take the battery out of its housing, and fit the replacement.

Watch the video!


by ScegliAuto

More videos