Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Complete Disassembly of Front Headlight

Model: Hyundai Elantra MK 3, XD - Years: 2000, 2001, 2002, 2003, 2004, 2005, 2006
Part: Headlight bulb

See other generations:
Video tutorial

To completely disassemble the front headlight assembly, open the bonnet and remove the two screws that secure the headlight. Carefully pull the headlight assembly out of its housing.

Remove the protective cap and then the connector for the electrical wires. Remove the retaining spring of the bulb by gently pulling it to detach it from the bulb holder.

Install the new bulb without touching the glass with your hands. Refit the bulb holder in its respective housing and reposition the headlight assembly in its place, closing the plastic cap and securing it with the two clips.


Updated on 8 February 2026 by ScegliAuto


Related tutorials

Installation of Aftermarket Xenon Kit
Installation of Aftermarket Xenon Kit
Hyundai Elantra (2015-2020 / MK 6) To carry out the installation, it is necessary to remove the headlights: disconnect the connector attached to it and proceed with removing the headli…
How to Remove the Front Headlamp on Hyundai Elantra
How to Remove the Front Headlamp on Hyundai Elantra
Hyundai Elantra (2015-2020 / MK 6) Want to remove the front headlamp from a Hyundai Elantra? Follow these steps: open the bonnet by pulling the release lever and secure it with the pro…
How to replace the headlight bulb of the Hyundai Elantra
How to replace the headlight bulb of the Hyundai Elantra
Hyundai Elantra (2010-2015 / MK 5, MD, UD) Replacing the left front headlight bulb of the Hyundai in London is a simple and quick operation to be carried out independently. To replace the bulb…

How to Extract the Spare Wheel from a Mercedes Vito

The spare wheel of a Mercedes Vito is located underneath the vehicle, just below the rear boot. This video demonstrates how to extract the wheel from its compartment. First, open the boot and locate the tools provided with the vehicle to release the wheel; these can be found in a compartment on the right side of the boot. As shown in the video, use the supplied screwdriver to remove the cover cap from the hole where you will insert the socket spanner; this hole is located beneath the rubber seal above the rear bumper. Insert the spanner and attach the extension to allow you to turn it and lower the wheel from under the floor. Finally, detach the pin that allowed the wheel to lower and proceed to extract it from under the vehicle.

Watch the video!


by ScegliAuto

More videos