Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Hyundai
    3. :
  3. ix20
    4. : How to replace the fog light bulbs on the Hyundai IX20.

Hyundai ix20 - Video tutorial

Model: Hyundai ix20 OJ - Years 2010-2019
Part: Checks and maintenance
Operation: How to replace the fog light bulbs on the Hyundai IX20.

Let's see how to replace the H7 bulb of the fog light on the Hyundai IX20: first, we need to release the two buttons that support the wheel arch under the bumper. We remove them with a screwdriver and move the plastic panel towards the wheel. Now we can access the fog light. We remove the connector and reach the bulb. We give it a quarter turn to remove it and insert the new bulb. Remember not to touch it with bare hands unless we want to significantly shorten its lifespan. We put the connector back in place. Now we can put the plastic cover back in place by closing the two buttons, and we're done.


Posted on 16 August 2023 by ScegliAuto

    Frequently Asked Questions

    • Ix20 2010-2019 - Where is the Hyundai Ix20 telepass installed? Read Answer
    • Ix20 2010-2019 - Why doesn't the tire pressure warning light on my Hyundai Ix20 go off? Read Answer
    • Ix20 2010-2019 - What are the lights of the Hyundai Ix20? Read Answer
    • Ix20 2010-2019 - What is causing the Hyundai Ix20 parking sensor problem? Read Answer
    • Ix20 2010-2019 - What warning lights are there in the dashboard of the Hyundai IX20? Read Answer
    • Ix20 2010-2019 - What does the ESP light on the Hyundai Ix20 indicate? Read Answer
    • Ix20 2010-2019 - Why does the steering of a Hyundai IX20 make noise? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos