Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing Rear Discs and Pads

Model: Jeep Commander MK 1 - Years 2005-2010
Part: Brake pads

Lift the vehicle on a hydraulic ramp and remove the rear wheel. Before unscrewing the brake caliper mounting bolts, lever between the disc and pads to retract the caliper piston, then unscrew the bolts and remove the caliper along with the disc. Extract the old pads and insert the new ones, install the new disc after cleaning it of protective oil residues, reposition the caliper in its place, and tighten the mounting bolts. Repeat the same procedure on the other wheel and pay particular attention during the initial braking.

Updated on 11 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacing the Mirror Cover on a Jeep Commander
Replacing the Mirror Cover on a Jeep Commander
Jeep Commander (2005-2010 / MK 1) Detach the mirror glass using a plastic lever, then open the door and start removing the panel by unscrewing the three bolts that secure it: one is n…
How to Replace the Air Filter on the Jeep Commander
How to Replace the Air Filter on the Jeep Commander
Jeep Commander (2005-2010 / MK 1) The following video tutorial shows how to independently replace the air filter on the Jeep Commander. The air filter box is located under the front b…

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos