Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Air Filter on the Jeep Commander

Model: Jeep Commander MK 1 - Years 2005-2010
Part: Air filter

The following video tutorial shows how to independently replace the air filter on the Jeep Commander. The air filter box is located under the front bonnet, specifically on the front right side of the vehicle. Replacing the filter is very important as it allows the engine to work less hard during startup. To replace it, open the front bonnet and unclip the cover of the box by lifting and pushing back the clips. Lift the cover and remove the filter. Clean the inside of the box from any dust and dirt residues. Insert the new air filter and close the cover by pushing on the clips.

Posted on 1 July 2026 by ScegliAuto

Video tutorial

Related tutorials

Where is the OBD2 port located in the Jeep Commander?
Where is the OBD2 port located in the Jeep Commander?
Jeep Commander (2005-2010 / MK 1) If you own a Jeep Commander and are curious about the location of the OBD2 port, all you need to do is follow the steps outlined in the following gui…
How do you reset the Service light on the Jeep Commander?
How do you reset the Service light on the Jeep Commander?
Jeep Commander (2005-2010 / MK 1) In order to reset the Service light of the Jeep Commander, you need to insert the ignition key into the slot, so that you can turn on the instrument …
Resetting the Service Light on Jeep Commander
Resetting the Service Light on Jeep Commander
Jeep Commander (2005-2010 / MK 1) In this brief video tutorial, you will learn how to reset the service light, specifically the oil change light, on a Jeep Commander, model produced f…

Other guides you may be interested in

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos