|
Do it yourself
| |||
| ||||
|
Model: Kawasaki Versys
To remove the side panels of the Kawasaki Versys fairing, loosen the bolts located at the top of the panel, just below the grips. These are 4 mm screws, while the screws securing the panel in the centre are 5 mm. Once these screws are also loosened, pry to disengage the retaining clips. Before completely removing the panel, disconnect the connector for the indicator light bulbs. At this point, you can install the new panel.
Updated on 24 April 2026 by ScegliAuto
Video tutorial
Related tutorials
Versys
Insert the ignition key into the designated slot on the side fairing, then remove the seat from the motorcycle. There you go! This operation will hel…
Versys
To replace the air filter on the Kawasaki Versys 650, remove the bolts securing the side panels of the bike just below the fuel tank and the screws h…
Versys
To replace the bulb on a Kawasaki Versys 650, remove the rubber protective cap located between the handlebars and the dashboard, disconnecting the co…
|
How to Service the Beta RR 350
This video will illustrate the steps to perform the routine maintenance service, replacing the engine oil and oil filter on the Beta RR 350 enduro bike. First, place the bike on a stand and start by loosening the oil drain bolt located under the engine, allowing it to drain into a container for about ten minutes; then clean the small oil filter (replacing it with a new one if too dirty). Finally, top up with new oil, of the correct type for your engine, filling to the maximum level! by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.006
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |
